本文へスキップ

Callaway

Callaway MD3 Milled ウェッジ

ツアーグラインド201548°-60°

The Mack Daddy 3 Milled is Roger Cleveland's wedge, and it plays like a wedge built by someone who has spent decades obsessing over how a ball comes off a face. Callaway offers it across seven lofts from 48 to 60 degrees, so you can build a full short-game setup around one model without mixing feels between your gap, sand, and lob wedges.

What sets the MD3 apart is Groove-in-Groove technology. Between the main grooves, Callaway milled a second set of micro-grooves running at a slight angle to the primary ones. The point is more contact points on the ball at impact, which means more spin, especially on those half and three-quarter shots where you are trying to check a ball up next to a tucked pin. It is not marketing fluff. You can hear and feel the ball grabbing the face.

Progressive lofts and progressive grooves mean this set is not one design stretched across seven heads. Lower lofts get narrower, deeper grooves for full-swing control. Higher lofts get wider, shallower grooves tuned for spin around the greens. If you play a 48 and a 60 out of this family, each one is optimized for the shots you actually hit with it.

要点

Callaway MD3 Milled (2015年) はグリーン周りで多彩なショットを打てるツアーグラインドウェッジです。ロフトは48°~60°です。2015年発売。

Callaway MD3 Milled ウェッジ: 主要スペック

カテゴリ
ツアーグラインド
目安ハンディキャップ
0~10
ロフト範囲
48~60度
ロフト/グラインドの組み合わせ
7
モデル年式
2015

購入先

各ショップの検索ページを開きます。価格と在庫は各ショップのものです。

今買うべきか、待つべきか?

買うか待つか

モデルチェンジ間近

このカテゴリーのブランドは約2年ごとにモデルを更新します。MD3 Milledは発売から11年たっても後継モデルがまだないため、いつ新モデルが出てもおかしくありません。今のうちに値下がり価格で買うか、数週間待って後継モデルを確かめましょう。

発売時期とこのシリーズの一般的なモデルチェンジ周期に基づく判断で、リアルタイムの価格見積もりではありません。

選べるバリエーション

ロフトバウンスグラインド仕上げ
48°10°Sクローム
50°10°Sクローム
52°10°Sクローム
54°10°Sクローム
56°10°Sクローム
58°10°Sクローム
60°10°Sクローム

ロフトとバウンスは公称値です。実際のスペックは異なる場合があります。

テクノロジー

鍛造プログレッシブロフト

Callaway MD3 Milledについて

The MD3 Milled is forged and then CNC milled on the face and grooves, which is why the shorthand name includes Milled. Milling the face gives Callaway tight tolerances groove to groove, and the forged carbon steel head delivers the soft, dense feel that better players want to hear on a delicate flop or a firm spinner. This is a players wedge in look and feel, with a compact head, thin topline, and minimal offset. Grind options were the other half of the story. Depending on loft you could get an S grind for versatility, a C grind with heel and toe relief for players who open the face and manipulate the club, or a W grind with more bounce for softer conditions and steeper attack angles. Matching the grind to your turf and your swing is the difference between a wedge that digs and one that glides.

Callaway MD3 Milledはどんな人に向いている?

  • ✓Mid to low handicappers who take a full or partial swing and want the ball to check on the second bounce.
  • ✓Players who want a matched set of wedges from gap through lob rather than a single hero club.
  • ✓Anyone who opens the face and works shots around the green and needs a grind that lets the club slide instead of dig.
  • ✓Golfers who prioritize spin and feel from forged carbon steel over the durability of a plated cast wedge.

関連記事

よくある質問

What is Groove-in-Groove technology on the MD3 Milled?

It is a second set of micro-grooves milled between the main grooves, angled slightly against them. The extra edges create more contact with the ball at impact, which adds spin on partial and open-face shots where you need the ball to stop quickly.

What grind should I get in the Callaway MD3 Milled?

It depends on your turf and technique. The S grind is the versatile all-rounder for neutral conditions. The C grind has heel and toe relief and suits players who open the face and hit a lot of finesse shots. The W grind carries more bounce and works better in soft turf and bunkers or if you have a steep angle of attack.

Is the MD3 Milled forged or cast?

It is forged from carbon steel with a milled face and grooves. The forging gives it the soft feel better players look for, and the milling keeps the grooves consistent for predictable spin.

Which lofts does the MD3 Milled come in and how should I set up my wedges?

It runs from 48 to 60 degrees in the 48, 50, 52, 54, 56, 58, and 60 options. Most players carry three or four wedges spaced about four degrees apart, for example a 50, 54, and 58, so you cover your gaps without leaving an awkward yardage between clubs.

Is the MD3 Milled a good wedge for higher handicappers?

It can be, but it is built for players who make consistent contact. This is a compact players wedge with a thin topline and less bounce in the lower-loft grinds. If you tend to hit it thin or fat, a wider-soled game-improvement wedge will be more forgiving, though you give up some of the feel and spin the MD3 delivers.

Callaway MD3 Milled ウェッジは高ハンディキャップのゴルファーに向いていますか?

いいえ。Callaway MD3 Milledはボールをしっかり打てるゴルファー向けのツアーグラインド設計です。このカテゴリーは一般にハンディキャップ0~10のゴルファーに合います。高ハンディキャップのゴルファーには、ゲームインプルーブメントモデルのほうがやさしく感じられます。

Callaway MD3 Milledの代わりになるモデル

ほかのブランドのツアーグラインド ウェッジのうち、発売年が近いモデルです。

Callawayのウェッジをもっと見る

自分のバッグに合うロフトを探す

ギャップファインダーで、今のセットに合うロフトの組み合わせを確かめましょう。

ギャップファインダーを開く →